www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93012107
InstructionSheet
6. CONNECT “S” HOOK IN FREE KEYHOLE OF PLASTER
FLANGE. ALLOW PENDANT TO HANG FREELY ON SAFETY
CABLE. SEE FIG 2C
7. LOCATE THE RED AND BLUE WIRES FROM PENDANT
ASSEMBLY AND PASS WIRES AND PROTECTIVE SLEEVE
THROUGH SLOTTED HOLE IN PENDANT BRACKET.
8. CONNECT WIRES FROM DRIVER HOUSING TO WIRES FROM
PENDANT (RED TO RED, BLUE TO BLUE) SECURING WITH
WIRE NUTS SUPPLIED.
9. PUSH WIRES BACK INTO HOUSING. ALL WIRES MUST BE
RUN THROUGH CENTER OF SLOTTED HOLE OF PENDANT
BRACKET. STRAIN RELIEF ON PROTECTIVE SLEEVE MUST
BE LOCATED ON INSIDE FACE OF PENDANT BRACKET
BEFORE SECURING MOUNTING PLATE IN PLACE.
10. HOLD PENDANT UP TO HOUSING FIXTURE, ALLOWING CEIL-
ING COVER
TO REST AT BOTTOM OF STEM DISENGAGE “S"
HOOK AND ALLOW SAFTY CABLE (WITH “S” HOOK) TO HANG
OUT SIDE OF HOUSING FIXTURE.
11. ALIGN HOLES OF PENDANT COVER PLATE TO HEX SCREWS
ON PENDANT BRACKET. TURN COUNTER-CLOCKWISE AND
TIGHTEN HEX SCREWS. SEE FIG 7.
12. PUSH “S” HOOK AND CABLE UP INTO HOUSING FIXTURE.
13. MOUNT CEILING COVER BY INSERTING TORSION SPRINGS
THROUGH SLOTS. SEE FIG 5B.
LED ARRAY REPLACEMENT
1. REMOVE THE TRIM BY LOOSING THE CAPTIVE SCREW.
2. DISCONNECT LIGHT ENGINE WIRE ASSY FROM DRIVER
WIRE ASSY.
3. LOOSEN AND REMOVE SAFETY CABLE FROM BOTTOM OF
REFLECTOR SUB-ASSEMBLY.
4. REMOVE (3) MOUNTING SCREWS FROM REFLECTOR.
REPLACE LIGHT ENGINE AND SECURE WITH (3) MOUNTING
SCREWS.
5. RECONNECT SAFETY CABLE TO LOWER HOLE IN REFLEC-
TOR. CONNECT REPLACEMENT LIGHT. ENGINE WIRE ASSY
T
O DRIVER WIRE
ASSY
.
6. SLIDE REFLECTOR AND LIGHT ENGINE SUB ASSEMBLY IN
PLACE.
7.
TIGHTEN CAPTIVE SCREW
.
LED DRIVER REPLACEMENT
1.
REMOVE PENDANT
FROM HOUSING REVERSING INSTRUC
-
TIONS IN STEPS 3-13 ABOVE. DISCONNECT ALL WIRING
NECESSARY TO REMOVE DRIVER. REMOVE (2) 8-32
SCREWS SECURING DRIVER. (SUPPLIED). REPLACE OLD
DRIVER WITH NEW ONE BY
TIGHTENING
THE 2 DRIVER
MOUNTING SCREWS. RECONNECT ALL WIRING REFERENCE
STEPS 2 AND 8 OF INSTALLATION INSTRUCTIONS
T
ORSION SPRING
PENDANT
BRACKET
S
LOT FOR TORSION
S
PRING (2X)
CEILING COVER
R
ETAINER
R
ING
STEM AND
P
ENDANT
PENDANT
C
OVER PLATE
BALL HALF
701 Millennium Boulevard • Greenville, SC 29607
W
ith representatives of
fices in principal cities throughout North
America.
Copyright 2009, 10/30/09 revision, All Rights Reserved - Printed in U.S.A.
FIG. 4
FIG. 5B
F
IG. 5A
FIG. 7
TAMPER PROOF
SCREW
FIG 6
LIGHT ENGINE
WIRE ASSEMBLY
DRIVER WIRE
ASSEMBLY
DRIVER
GROUND WIRE
WHITE TO WHITE
BLACK TO BLACK
WIRENUT (3)
(NOT SUPPLIED)
CHAIN
DRIVER HEAT SINK
BRACKET GROUND
WIRE
CANOPY
JBOX GREEN
GROUND WIRE
MOUNTING
BRACKET
8-32 FLAT HEAD
SCREWS
(SUPPLIED)
TAMPER PROOF SCREW
LIGHT ENGINE
WIRE ASSEMBLY
WIRE ASSEMBLY
SAFETY
CABLE
FOR SDPSLED
FOR RDPSLED
CEILING OUTLINE
CEILING OUTLINE
FIG 2
FIG 3
FIG 4
(1 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais